epoxy coat floor coating
Cash back referral program
High Gloss Concrete Finish

Do I need to purchase the clear top coat to get the high gloss finish? NO! Both base and top coats have equal gloss levels however when you apply an additional clear coat the light will reflect on a smoother surface and will therefore look glossier.


PRODUCT DATA SHEET

Epoxy-Coat is a Cycloaliphatic epoxy formulated for high build applications on concrete or wood floors. It will create a hard, tough film with abrasion resistance, chemical resistance with less yellowing than standard epoxies. Complies with all VOC and VOS regulations.

TYPICAL PROPERTIES
Solids-100%
Color-Clear
Flash Point, Setaflash, F-230
Pounds/gallon- 8.44
Mixed Viscosity, cps with Part B activator -600-2000
Application recommended thickness from 16 mils DFT to 1/2
Solvent odor - None

DRYING CHARACTERISTICS
Based on 70 degrees F surface and environment temperatures:
Surface dry for traffic- 24 hours
Surface dry for re-coat - 0-18 hours
Note: Color coats may be longer
Full Cure- 3 days

MIXING INSTRUCTIONS
Mix 2 parts "resin" to 1 part "hardener" by volume and mix with a jiffy type mixer for 3 minutes, minimum. Refer to Epoxy-Coat mixing instructions for further details.

APPLICATION METHOD
Residential Applications: Recommended surface preparation is mechanical shotblasting/diamond grinding or Epoxy-Coat clean and prep solution. Squeegee and back roll with thin nap roller.

Commercial Applications: Recommended surface preparation is mechanical shotblasting or scarifying. Prolonged or frequent contact with the resin (Part A) may cause dermatitis, sensitization, or other allergic responses. Good industrial hygiene practices should be observed in working with these materials. Before using them, consult the applicable Material Safety Data Sheets for appropriate handling procedures and protective equipment.

STORAGE
Epoxy-Coat should be stored in tightly sealed containers at normal room temperatures. Color of the curing agent may darken during long-term storage, the extent of color formation depending on storage temperature and degree of exposure to air.

PRECAUTIONS
The curing agent (Part B) may cause chemical burns in eyes or on skin, sensitization or other allergic responses, and can cause respiratory irritation. In large quantities, uncontrolled mixing with epoxy resins can result in runaway exothermic reactions.

Caution: Non-skid additives should be used where slipperiness may be a problem.

CURED STATE PROPERTIES
Heat Deflection Temperature C-48
Tensile Strength, psi -5349
Tensile Elongation at break, percent - 16
Compressive Strength, Ultimate, psi-12,800
Compressive Yield Strength, psi -0.98
Izod Impact, ft-lb./inch notch -.606
Taber Abrasion CS-17, 1000 G., 1000 cycles-48 mg. wt. loss
Reported as percent weight change of immersed 1” by 3” by 1/8” samples at 25 degrees C. ONE WEEK
5% Detergent - .58
5% Acetic Acid - .71
20% Acetic Acid- 3.31
50% Acetic Acid- Destroyed
10% Sulfuric Acid - .77
25% Sulfuric Acid - .69
70% Sulfuric Acid - .11
98% Sulfuric Acid -Destroyed
5% Nitric Acid- .74
20% Nitric Acid-1.35
10% Hydrochloric Acid-.51
10% Sodium Hydroxide- .45
50% Sodium Hydroxide-.03
5% Citric Acid-.60
5% Lactic Acid -.59
Methyl Ethyl Ketone-Destroyed
Xylene -.09
Toluene- .18
Ethanol -7.06
Methanol- Destroyed
Isopropanol-.26
Gasoline-.05
Antifreeze-.02
Brake Fluid - .89
Transmission Fluid-.09
Skydrol (500B4)- .01
Bleach-.45
3% Hydrogen Peroxide -.59
50% Sugar Solution -.49


  • Heat Deflection Temperature is defined as the temperature at which a polymer sample deforms under a specified load.
  • Tensile Strength is define as the resistance of a material to a force tending to tear it apart, measured as the maximum tension the material can withstand without tearing.
  • Compressive Strength is defined as the amount of resistance of a material to fracture under compression.
  • Izod Impact is defined as the resistance of a material to the impact of a suddenly applied force.
  • Taber Abrasion is defined as the resistance to wear.












BUY DIRECT FROM THE MANUFACTURER!

Our affiliate companies can service all your floor application and surface preparation needs!
Call today for assistance.


© 2008  Epoxy-Coat floor coating - Epoxy Garage Floor Coating

Epoxy Floor - Concrete Floor Paint - Garage Flooring

If you need an Epoxy Floor or Concrete Floor Paint or maybe Garage Flooring, you have come to the right website.